AutoTuner

🇩🇴 ¡Hola República Dominicana 🇩🇴
¡Nos complace presentar a nuestro distribuidor oficial, Speed Motoring Solutions, en Santo Domingo, República Dominicana!
👉 Ponte en contacto con ellos a través de nuestra sección de distribuidores: https://www.autotuner.com/pages/dealer/speed-motoring-solutions-spemotso-srl !

🇩🇴 Hello Dominican Republic 🇩🇴
We are pleased to introduce our official dealer, Speed Motoring Solutions, in Santo Domingo, Dominican Republic!
👉 Get in touch with them through our dealer section: https://www.autotuner.com/pages/dealer/speed-motoring-solutions-spemotso-srl !

HYBRID & EV RELEASE: Bosch VC1CP010 goes live on Bench!

Take full electronic control over modern hybrid and 100% electric platforms across the Alliance (Renault, Alpine, Dacia, Nissan, Mitsubishi) on your AutoTuner Tool! The Bosch VC1CP010 control unit is now supported in Bench mode (following Mail-in Unlock). 🚀

This update unlocks the new 6AK & 6AM electric motor series (Renault 4, 5, Alpine A290, Megane & Scenic E-Tech). These powertrains share identical hardware across factory-detuned output levels (95 to 220 hp), opening up exciting new electronic calibration possibilities! 📈⚡

Supported Lineup:
✅ 1. 100% Electric EV Range: Renault 4, 5, Megane, Scenic (6AK & 6AM motors), Alpine A290, Dacia Spring, Nissan Ariya, Leaf, Micra & E-Tech commercial vans.
✅ 2. Hybrid Range (E-Tech): Renault Austral, Rafale, Espace, Symbioz, Arkana, Captur, Clio, Dacia Duster, Bigster, Jogger, Nissan Juke & Mitsubishi ASX.

💡 Hardware Tip: Connect on bench quickly and accurately using our dedicated AutoTuner Bench Cable!

Update your Tool software today and elevate your hybrid & EV capabilities!

More info: https://www.autotuner.com/blogs/news/bosch-vc1cp010

🇸🇪 WORLD-FIRST VOLVO EXCLUSIVE: Denso VEA Gen 2 (SPC5777M) goes live on Bench! ⚡🚗

Major update landing on your AutoTuner Tool! We are thrilled to launch official Bench mode support for the Denso VEA Gen 2 ECU family powering the Volvo Drive-E lineup! 🚀

⏳ A Look Back: In 2018, AutoTuner was the very first to release support for the initial Volvo Denso ECUs (SH72546). However, the newer Gen2 ECUs powered by the Freescale SPC5777M processor remained unreadable and unwriteable since late 2017... Until today! 💥

To streamline your workflow, an OBD patch is also available following a one-time Bench unlock.

💡 Note: For vehicles equipped with a Secure Gateway (SGW), we advise working in Bench mode to avoid long reading and writing procedures.

Supported Fleet:
✅ Sedans & Wagons: S60, S80, S90, V40, V60, V70, V90 🚗
✅ SUVs & Crossovers: XC40, XC60, XC70, XC90 🚙
✅ Engines: Diesel (B4, B5, D2-D5) & Petrol / Hybrid (T2-T8, B3-B6) ⛽⚡

Update your AutoTuner software today and take full advantage of this exclusive new protocol! 🔌

More info: https://www.autotuner.com/blogs/news/denso-vea-gen2-spc5777m

OPEL & VAUXHALL RELEASE: Siemens SIMTEC71 goes live via 100% OBD NR! ⚡🚗

Supported Fleet Highlights: -
✅ Opel / Vauxhall Astra, Corsa, Tigra & Vectra (1.8i Ecotec) 🚗 -
✅ Opel / Vauxhall Zafira & Omega (2.2i) 🚙
✅ Subaru Traviq (1.8i Ecotec) 🇯🇵

Update your Tool software today and elevate your workshop capabilities! 🔌

More info: https://www.autotuner.com/blogs/news/siemens-simtec71

FORD & LINCOLN RELEASE: Continental EMS2211, EMS2301, EMS2302 & EMS2701 ECUs go live via 100% OBD NR!

Take full engine management control over Ford and Lincoln petrol, hybrid (HEV/FHEV), and plug-in hybrid (PHEV) platforms on your AutoTuner Tool! 🚀

Supported Fleet Highlights:
✅ Ford Ka, Fiesta, Focus, B-Max & EcoSport
✅ Ford Kuga, Escape, Maverick & Galaxy (2.5 FHEV / PHEV)
✅ Ford Mondeo & C-Max (2.0 HEV)
✅ Lincoln Corsair & MKZ

Update your Tool software today and elevate your workshop capabilities! 🔌

More info: https://www.autotuner.com/blogs/news/continental-ems2211-ems2301-ems2302-ems2701

FORD V6 ECOBOOST RELEASE: Bosch MG1CS018 goes live via 100% OBD VR! 🇺🇸🛻⚡

Take full engine management control over Ford V6 EcoBoost and hybrid powertrains on your AutoTuner Tool! The Bosch MG1CS018 ECU is now supported directly through the diagnostic port via 100% OBD Virtual Read. 🚀

Supported Fleet Highlights:
✅ Ford F150, Transit & Ranger V6 EcoBoost 🛻
✅ Ford Explorer & Edge 🚙
✅ Lincoln Aviator 🇺🇸

Update your Tool software today and elevate your workshop capabilities! 🔌

More info: https://www.autotuner.com/blogs/news/bosch-mg1cs018

BMW GROUP RELEASE: Bosch MD1CP002, MD1CS001 & MG1CS003 go live on direct Bench! 🇩🇪⚡🚗

As promised, no more ECU shipping required! Official support for Bosch MD1CP002, MD1CS001 & MG1CS003 ECUs (SPC5777M MCU) is now available directly in Bench mode instead of Mail-in Unlock! 🚀

Supported Fleet Highlights:
✅ BMW 1 to 8 Series, X1 to X7, Z4 (16d to M50d & 18i to M40i/50i)
✅ Mini (Clubman, Cooper, Countryman 1.5d/2.0d)
✅ Alpina (D3 S, D5 S, XD3, XD4)

💡 Hardware Tip: Speed up your workbench setup with our dedicated BMW MDG1 Bench Cable! 🔌

Update your AutoTuner software today and elevate your BMW calibration capabilities!

More info: https://www.autotuner.com/blogs/news/bmw-dme8-md1cp002-md1cs001-mg1cs003

🇺🇸 Hello USA! 🇺🇸

We are pleased to introduce our official dealer, Precision Auto Solutions - Sponsored By Foreign Performance Automotive, in Miami, Florida, USA!

👉 Get in touch with them through our dealer section: https://www.autotuner.com/pages/dealer/precision-auto-solutions-sponsored-by-foreign-performance-automotive!

🇿🇦 Hello South Africa! 🇿🇦

Weare pleased to introduce our official dealer, ECU Technologies, in Cape Town, South Africa!

👉 Get in touch with them through our dealer section: https://www.autotuner.com/pages/dealer/ecu-technologies-cc!