ZenModeling

My Instagram acct with this same Handle of , was SUSPENDED & DEACTIVATED a few days ago. Reason given was Copyright infringement, displaying a Post-Photo from the alleged infringement that was my dog Moose. The Post was made 5-YEARS AGO…..🤔 ……I filed an appeal & waiting to see. Till then I’m in the IG 🕳️ shackled to a Temporary IG handle of 🤓☯️Lee

👉Set of Brake Disc’s I machined & fitted a Caliper + some P/E Detail.
I can’t believe how much I used to pay guys to make this stuff for me😉

Some of the Fittings I made from Stainless Steel Tubing, combined with Banjo fittings & the Custom Scratch P/E Anchor Mounts for the fittings. All locked down with a cotter pin. 🤓

Fuel Tank I machined on my Mill, after adding my Weld-Bead Detail✅
👉Added a few of the 1:1 photos for comparison.

Machined the 1st step on a New “Puke-Tank”. Simple facing off sides. Popped on the Radius cutter & made the taper.
📍Step 2 on the Mill for the 2 pipe sections that feed in-&-out of the sides.
Followed by my Weld-Bead detail & A/B Black + Livery Decal.

📍Added 74 Weld-Bead’s to New frame.
📍Completed all removable crossbars.
📍New frame primed.
📍New Chromoly color.
👉A/B’ing Base coat 1st thing in the am. 🤓
Lee

Cutting C/F Template's for the backside of the Removable center panel & the Reverse side of both Kick-Out's.

Velocity Stacks I machined on my Lathe, for the McLaren side build.
👉Used the [Compound Slide] attachment to shape the aluminum rods into the Flare, combined with a Boring cutting tool. 1st time attempting to make these. 🤓

👉PhotoEtch supports in 1:1 fashion. For the New Body section complete with all the Dzus plates.
📍Going into PaintBooth next for Primer & Base Coat. Then for C/F on the inside section’s 😬